Magnepan MG 3.7 User Manual download pdf (Page 2)

Magneplanar 3.7i Instruction Manual

Quick Step-Up Instructions

e 3.7i has exceptional phase characteristics that are accomplished without

the use of compensation networks. To realize the optimum phasing, the 3.7i

should be angled inward as shown in the diagrams in the manual. (Do not

place parallel to the front wall.) e most precise imaging for a single listener

is with the tweeters on the inside. For a larger “sweet spot” and multiple

listeners, place tweeters on the outside. But, in both cases, the speakers must be

angled inward as shown in the diagrams below .

Your 3.7is have been shipped with the tweeters disconnected.

You must install a resistor or jumper for the operation of the tweeters. Most

listening rooms will have the smoothest response when using the enclosed 1

ohm resistors for the tweeter and midrange. Rooms that are large and/or

overly-damped may require the enclosed jumper for smooth response.

e 3.7i provides more options for getting the bass just right for your

particular room. ere is no one-size-ts-all for every room. e 3.7i has

provisions to adjust the relative levels of the bass, midrange and tweeter. e

default position for most rooms requires attenuation of the midrange and

tweeter with resistors. If that does not achieve a smooth balance in your room,

additional bass diaphragm area can be added with one or more Maggie Bass

Panels.

Revised 2-27–2015

Page of 2 9

1 2 3 4 5 6 7 8 9

No comments

Magnepan MG 3.7 User Manual Page 2