Magnepan DW1 User Manual download pdf (Page 2)

4. Hookup

To install the speaker cable, first strip off approximately 1/4-inch of insulation from the speaker cable end. Remove

the metal hold-down and wire retainers from the bottom of the DW 1 with a Phillips screw driver and pliers. See Fig.

Cosmetically, the front and back of the DW 1 are identical. To identify the back of the speaker and ensure proper

phasing, the back of the DW 1 can be identified as shown in Fig. 1.

Connect the output of a high pass crossover (such as the Magneplanar XO 2) to the input of the DW 1, observing

correct polarity. However, due to different crossover designs, following correct polarity does NOT ensure that the DW

1 will be in correct acoustical phase. See "Phasing" below.

Fig. 1

1 2 3 4 5

No comments

Magnepan DW1 User Manual Page 2